Login ProductsSalesSupportDownloadsAbout |
Home » Technical Support » ElevateDB Technical Support » Support Forums » ElevateDB SQL » View Thread |
Messages 1 to 4 of 4 total |
REPAIR OnStatusMessage says VERIFY as oppose to REPAIR ? |
Wed, Jun 20 2012 5:35 AM | Permanent Link |
IQA | Hi,
I have an OnStatusMessage setup on a TEDBQuery component. When I run say "REPAIR TABLE purpose" the status messages speak of verify but no mention of repair... Is the table getting repaired OR verified OR is the MessageStatus incorrect in the source code? Optimise appears to give the correct messagestatus..... Verifying the table purpose... Verifying the table purpose - Verifying rows (structure-only)... Verifying the table purpose - Verifying index PrimaryKey (structure-only)... Verifying the table purpose - Verifying table contents (logical)... The table purpose was verified successfully |
Wed, Jun 20 2012 8:55 AM | Permanent Link |
Roy Lambert NLH Associates Team Elevate | Phil
As a guess there was no fault to repair. Roy Lambert [Team Elevate] |
Wed, Jun 20 2012 2:16 PM | Permanent Link |
Tim Young [Elevate Software] Elevate Software, Inc. timyoung@elevatesoft.com | Phil,
<< When I run say "REPAIR TABLE purpose" the status messages speak of verify but no mention of repair... Is the table getting repaired OR verified OR is the MessageStatus incorrect in the source code? Optimise appears to give the correct messagestatus..... >> The messages are correct - the repair works by verifying the table and, if any errors are found, then you'll see a "fixed xxxx" type of message. If you have any other questions, please let me know. Tim Young Elevate Software www.elevatesoft.com |
Wed, Jun 20 2012 6:39 PM | Permanent Link |
IQA | > The messages are correct - the repair works by verifying the table and,
> if any errors are found, then you'll see a "fixed xxxx" type of message. > > If you have any other questions, please let me know. No that's fine, I wanted check it was right cause it's just alittle confusing in a program using these status messages as it's identical to the verify and doesn't mention 'nothing to repair' or even the word repair, but all good I just wanted to make sure. I didn't have a broken table to test with. Thanks, Phil |
This web page was last updated on Wednesday, June 12, 2024 at 01:54 PM | Privacy PolicySite Map © 2024 Elevate Software, Inc. All Rights Reserved Questions or comments ? E-mail us at info@elevatesoft.com |