![]() | ![]() Products ![]() ![]() ![]() ![]() |
Home » Technical Support » Elevate Web Builder Technical Support » Support Forums » Elevate Web Builder General » View Thread |
Messages 1 to 2 of 2 total |
![]() |
Thu, May 9 2013 12:41 PM | Permanent Link |
Matthew Jones | If I let the application auto-create a form, it works just fine with ShowModal, and
ModalResult works etc. If I don't auto-create it, but create it "manually" later, it doesn't behave properly - it appears, but the modal parts don't work. Given the auto-create is just frmFeedback := TfrmFeedback.Create(Application); how can this be? I see that there was an discussion about not accessing the variable within the constructor, but I would expect it to work on the line following the creation. This isn't critical - I can auto-create - but I'd like to understand it as this form isn't important and I'd like it not to sit around. /Matthew Jones/ |
Fri, May 10 2013 4:30 PM | Permanent Link |
Tim Young [Elevate Software] Elevate Software, Inc. ![]() | Matthew,
<< If I let the application auto-create a form, it works just fine with ShowModal, and ModalResult works etc. If I don't auto-create it, but create it "manually" later, it doesn't behave properly - it appears, but the modal parts don't work. Given the auto-create is just frmFeedback := TfrmFeedback.Create(Application); how can this be? >> It works fine here in the 1.02 candidate, so I'm going to have to go back to 1.01 and confirm if that's still the case. Tim Young Elevate Software www.elevatesoft.com |
This web page was last updated on Friday, February 14, 2025 at 12:13 PM | Privacy Policy![]() © 2025 Elevate Software, Inc. All Rights Reserved Questions or comments ? ![]() |