![]() | ![]() Products ![]() ![]() ![]() ![]() |
Home » Technical Support » Elevate Web Builder Technical Support » Support Forums » Elevate Web Builder General » View Thread |
Messages 11 to 12 of 12 total |
![]() |
Mon, Jan 11 2016 1:15 PM | Permanent Link |
Tim Young [Elevate Software] Elevate Software, Inc. ![]() | Raul,
<< if i leave "replace all" checked but keep responding with Yes to every prompt then it keeps jumping between the 2 with statements. Similarly with No - keeps jumping between 2 with statements. >> Duh ! I should have known by the words being used what is going on. It keeps trying to replace what it has already replaced, due to the case-insensitivity. I still can't reproduce it here, but I think it has to do with the scope or something that I need to look into. Thanks, Tim Young Elevate Software www.elevatesoft.com |
Mon, Jan 11 2016 1:16 PM | Permanent Link |
Tim Young [Elevate Software] Elevate Software, Inc. ![]() | Raul,
<< It's the environment Editor setting "Find Wrap Around" - if checked it locks up the IDE. >> Darn it, I was just about to post that. I just noticed in the IDE code that it was dependent upon that setting. ![]() Thanks, Tim Young Elevate Software www.elevatesoft.com |
« Previous Page | Page 2 of 2 | |
Jump to Page: 1 2 |
This web page was last updated on Friday, July 26, 2024 at 04:41 PM | Privacy Policy![]() © 2024 Elevate Software, Inc. All Rights Reserved Questions or comments ? ![]() |