Tim, seems that there is a problem with EWB 2.02 B2 when resizing a
TDialog in the IDE with the mouse.

The following error is displayed:

(GDI+ Error) One of the arguments passed to the method was not valid.

The form then disappears from the IDE.

--
Rick

Rick:

Did you do an Incident Report?  Bugs get addressed faster when reported.

I tested and get same fatal issue.

Walter

I just submitted an incident report in case one has not been submitted.

Walter

Rick wrote:

> with the mouse.

Is it okay to use the properties to set the size? I'd like to get some
of the fixes, but this may be critical.

--

Matthew Jones

On 23/10/15 21:15, Walter Matte wrote:
> I just submitted an incident report in case one has not been submitted.

Thanks. No, I hadn't submitted an incident report. I usually do but Tim
has said that he would use these forums for support purposes.Considering
that build 3 was just released I assumed he would check here first for
feedback.

You are correct though, always best to raise an incident.

--
Rick

On 23/10/15 21:34, Matthew Jones wrote:
> Rick wrote:
>
>> with the mouse.
>
> Is it okay to use the properties to set the size? I'd like to get some
> of the fixes, but this may be critical.
>

Yes, properties altered in the Object Inspector, including width/height,
don't appear to cause the problem. If it does occur, closing and
re-opening the project brings everything back correctly.

--
Rick

Rick,

<< Tim, seems that there is a problem with EWB 2.02 B2 when resizing a TDialog in the IDE with the mouse. >>

This is now fixed, and I'll be doing a new build by tomorrow with the fix.

Tim Young
Elevate Software
www.elevatesoft.com